google.com, pub-8658045329707802, DIRECT, f08c47fec0942fa0
Upwork Test Answers: Get all the correct answers of most recent and possible Upwork Tests A to Z (Updated on Jan, 2016)
Cover Letter Templates: These cover letter samples are not only for Upwork job, but also you will have some idea about your real life job
 
Freelance Profile Overviews: Different Profile samples and overviews of experts, advanced and intermediate level freelancers
For Newbie of Upwork: Upwork Help - How to apply for a job in Upwork with 10 most important articles about Upwork

A to Z View - All Upwork Test Answers

Electronic Design Test Answer

A Colpitt’s oscillator uses _____.
Answers: • both a tapped inductor and a tapped capacitor

A Wien-bridge oscillator is basically a _____.
Answers: • sine-wave generator

A voltage V=300cos100t is applied to a half wave rectifier with RL =5KΩ. The rectifier may be represented by an ideal diode in series with a resistance of 1KΩ. What would be the ripple factor in this case?
Answers: • 100%

A bridge rectifier circuit has secondary voltage of 12Vr.m.s. Assume secondary resistance and diode forward resistance to be negligible. The load resistance is 100Ω. What would be the peak load current?
Answers: • 0.169 Amp

A half wave rectifier supplies power to 1000Ω load from a 110V (r.m.s) source of supply. If the forward resistance of the diode is 20Ω. What would be the efficiency of the rectifier?
Answers: • 39.73%


After triggering an SCR , the gate pulse is removed. the current in the SCR will _____.
Answers: • remain the same

A feedback amplifier has an internal gain = 40dB and a feedback factor = 0.05, if the input impedance of this circuit is 12KΩ. What would have been the input impedance of the amplifier if the feedback had not been present?
Answers: • 2KΩ

An amplifier has a gain of 10 without feedback. To make it oscillate, ß must be _____.
Answers: • 0.1

For designing a Push-Pull amplifier, the type of transistors should be _____.
Answers: • both should be n-p-n only

A crystal oscillator provides very stable frequency because of _____.
Answers: • the high Q of the crystal

A transistor is a semiconductor switch which is _____.
Answers: • unilateral and bistable

An Emitter follower is used for _____.
Answers: • impedance matching

An amplifier has a bandwidth of 200KHz and a voltage gain of 100. What will be the new bandwidth if 5% negative feedback is introduced?
Answers: • 1200KHz

A differentiator converts a linear ramp into a _____.

Answers: • constant D.C signal

No comments:

Post a Comment